Choose ESD Protection Option Yes, an ESD Protected Kit No, not an ESD Protected Kit

Choose a Pan Depth 2.5" Pan 4.0" Pan 6.0" Pan 8.0" Pan 10.0" Pan Slope No Pan (Upper Head Only) 8.0" Pan ** Special Order, Consult Factory 8.0" Pan ** Contact Factory for Availability

Choose a Micro Switch Option Yes, Include Micro Switch No Micro Switch

Choose a Gas Arm Option Yes, Include Gas Arm for Lid Assembly Standard Carlson Spring Supports

Choose Riser Block Size No Riser Blocks .250" Riser Blocks .500" Riser Blocks .750" Riser Blocks 1.00" Riser Blocks

Kit Size

Choose a kit size based on the size of your printed circuit board to be tested.

Upper Head Option

The Upper Head consists of the 1/2" thick clear polycarbonate lid, handle assembly, hinge assembly, and latch blocks.

Stripper Plate

A Stripper Plate is a spring-loaded FR4 plate that helps support the unit under test (UUT). It also protects the probes from damage.

ESD Protection

The ESD option is recommended when there are static sensitive devices on the U.U.T.  It consists of a Static Dissipative laminate bonded to the FR4 probe and stripper plates.  The Polycarbonate lid is also ESD coated.

Pan Depth

The sheet metal pans provided on Semco kits are available in different depths, allowing components, cooling fans, or additional hardware to be installed inside the pan.

Gas Arm / Carlson Hinge Spring Supports

The Gas Arm lid option replaces the standard Carlson spring hinges.

Microswitch

When the Microswitch opton is installed in the fixture, it signals "Begin Test" when actuated by closing the top lid.

Riser Blocks

Riser Blocks raise the polycarbonate lid to accommodate tall components on the UUT (Unit Under Test).  Riser blocks are recommended when you have components taller than 1.2".